There are no products

0,00 € Shipping
0,00 € Total

These prices understand themselves Excl. VAT




Best sellers!

» All best sellers


Bar angle 130 ° stainless steel satin finish


Bar angle 130 °. Stainless steel. Finish satinwith support in stainless steel AISI304 of 3 mm with rose, anti-vandal and maximum robustness.

More details

Notify me when available
38,00 € VAT excl.

Bar angle 130 °. Stainless steel. Satin finish.


Bar angle 130 ° stainless steel. Satin finish. Diameter 32 mm. Stainless Steel AISI 304 and 1.5 thick bent on both ends 90 degrees.

Handle of two points of support for horizontal installation wall bent with an angle of 130 ° at its midpoint. The two supports are made of 0.5 mm stainless steel AISI304 sheet thick, are 3 holes that allow the attachment of the bar to the wall. The soldier set, has a stainless steel satin finish. The separation of the bar to the wall is 43 mm, so it is compatible with U.S. regulations removal of architectural barriers (ADA).

The bar, anchored to a wall of brick by 6 pads of wavy 8 x 50 mm. and screws of stainless steel AISI304 5 x 60 mm, supports a maximum of 120 Kg static and dynamic strength.

Important: According to the low voltage regulation, any metallic element mounted in a bath or wet area, must be grounded or insulated electrically





-Material: Stainless steel

-Finish: Satin

-Supported maximum force: 120 Kg.

-Dimensions: 57'5 cm. x 29 cm. x 85 cm. x 3'2 cm. of diameter

-Weight: 1.20 Kg.


There are no customer comments for the moment.

Enter your comment

Enter your comment


30 other products in the same category: